Configuring The Device As Access Point; Using Access Point Mode - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide

Configuring the Device as Access Point

System > Operation Mode
Í Note: By default, the device function is set to Access Point mode.
1
Log into your access point management page (refer to
on page 10).
2
Click System > Operation Mode.
3 In Operation Mode section, select Access Point.
4
Click Apply to save changes.
Í Note: To discard the changes, click Cancel.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Log in to Management Page"

Using Access Point Mode

Wireless 2.4GHz or Wireless 5GHz >
1
Log into your access point management page (refer to
on page 10).
2
Configure the following settings, click Apply when finished.
• Wireless Mode: Choose between N only, G only, B only, B/G mixed, or B/G/N
mixed mode. The rule of the thumb is to choose single mode if your devices all
work in the same mode. Mixed mode increases compatibility, but sometimes
lowers the data speed.
or
• Channel Width: Select the appropriate channel width for your wireless network.
ƒ 20 MHz: This mode operates using a single 20MHz channel for wireless
devices connecting at 802.11n on both 2.4GHz and 5GHz. This setting may
provide more stability than Auto 20/40MHz for connectivity in busy wireless
environments where there are several neighboring wireless networks in the
area.
ƒ Auto 20/40MHz: When Auto 20/40MHz is active, this mode is capable of
providing higher performance only if the wireless devices support the channel
bandwidth settings. Enabling Auto 20/40MHz typically results in substantial
performance increases when connecting an 802.11n client.
ƒ The 40 MHz channel width allows for twice the usable radio spectrum to
transmit data, doubling performance compared to a normal 20 MHz channel
width.
TEW-821DAP
Wireless Network
"Log in to Management Page"
15