Connect Wireless Devices Using Wps; Pbc (Software/Virtual Push Button) - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide

Connect Wireless Devices Using WPS

WPS (Wi-Fi Protected Setup) is a feature that makes it easy to connect devices to your
wireless network. If your wireless devices support WPS, you can use this feature to easily
add wireless devices to your network.
You will not be able to use WPS if you set the SSID Broadcast setting to Disabled
ÍNote:
or if you are using WEP security. Please note that WPS functionality will only be
available when the Device Mode is set to Access Point mode under Main > Device
Mode.
There are two methods the WPS feature can easily connect your wireless devices to your
network.
• Push Button Configuration (PBC) method
• PIN (Personal Identification Number) method
Refer to your wireless device documentation for details on the operation of
ÍNote:
WPS.
© Copyright 2015 TRENDnet. All Rights Reserved.

PBC (Software/Virtual Push Button)

Wireless 2.4GHz > WPS
1
Log into your access point management page (refer to
on page 10).
2
Click Wireless 2.4GHz > WPS.
3
In WPS Config section enable the WPS feature.
4
Enable or disable the WPS External Registrar
5
In the WPS Action section, click Start Push Button to add a wireless device to your
network.
6
Wait for your access point to finish the WPS process.

The procedure is complete when the WPS Current Status in WPS Summary section
becomes "Idle".
TEW-821DAP
"Log in to Management Page"
Lock.
38