Configure Snmp Settings; Management > Snmp Settings - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide
3
Configure any of the following parameters for 2.4G or 5G profile:
• Outgoing Traffic Limit: Set the traffic limitation going through the wireless
interface. The default value is 180Mbps (180,000). The number can be set from
512 to 99,999,999. The traffic will be limited by this value and physical speed
whichever is lower. (The TEW-821DAP wireless interfaces are capable of 300
Mbps, 300,000 kbps for 2.4GHz and 5GHz respectively.)
• Incoming Traffic Limit: Set the traffic limitation going through Ethernet port. The
default value is 10Mbps (10,000). The number can be set from 512 to 99,999,999.
The traffic will be limited by this value and physical speed whichever is lower. (The
TEW-821DAP Ethernet port is capable of 1Gbps, 1,000,000 kbps.)
• Total Percentage: This value adds up all numbers in following 8 SSID percentage
settings. This value may exceed 100, up to 800. The traffic limit of this wireless
interface is calculated as: Outgoing Traffic Limit * Total Percentage.
• SSID (1 - 8): Set the number you want to shape your traffic for clients connects to
specific SSIDs by increasing or decreasing the value. The default value is 10 (%).
The number can be set from 0 to 100. The traffic limit of this SSID is calculated as:
Outgoing Traffic Limit * Total Percentage.
4
Click Apply to save the changes or Cancel to discard the changes.
© Copyright 2015 TRENDnet. All Rights Reserved.

Configure SNMP Settings

Management > SNMP Settings
SNMP Settings allows you to assign the contact details, location, community name and
trap settings for SNMP. This is a networking management protocol used to monitor
network-attached devices. SNMP allows messages (called protocol data units) to be sent
to various parts of a network. Upon receiving these messages, SNMP-compatible devices
(called agents) return data stored in their Management Information Bases.
1
Log into your access point management page (refer to
on page 10).
2
Click Management > SNMP Settings.
TEW-821DAP
"Log in to Management Page"
41