Table of Contents
Advertisement
CAUTION
Metal objects between the pad and the phone to be charged can become hot
■
due to the action of the induction field - this is a risk of damage to the tele-
phone.
With some phones, the charging process can be interrupted or the phone
■
can switch off due to heating up.
Do not insert any electronic or magnetic storage media (e.g. SD cards, USB
■
sticks, cards with magnetic strips or chips) between the pad and the phone to
be charged- there is a risk of data loss and damage to these data carriers.
If a message appears in the Infotainment screen that the phone cannot be
■
charged, then proceed as follows.
Check that there is no object between the support and the phone to be
■
charged. If this is the case, then take out the object and the phone. Place the
phone centrally on the phone symbol on the pad again.
Check if the position of the phone to be charged has not changed during
■
the journey. If this is the case, then take out the phone and put it back cen-
trally on the phone symbol on the pad.
Note
At the start of the wireless charging, the appropriate message appears on
■
the Infotainment screen.
For the optimum phone signal strength and uninterrupted wireless charging,
■
we recommend position the phone in the storage compartment without the
protective sleeve, if possible.
Insert a max. 160x84 mm into the storage compartment.
■
USB inputs
Fig. 97 Front USB input/rear USB inputs
92
Operation
Read and observe
and
The USB input is above the storage compartment in the front centre console
and, depending on the equipment, also in the rear centre console
The USB input in the front centre console can be used for charging and for da-
ta transmission. The USB inputs in the rear centre console can be used only for
charging.
Information for use
» page
149, USB input.
Cup holders
Fig. 98 Cup holder at the front/rear
Read and observe
and
The cup holders are located in the front centre console
rest
» Fig.
98.
B
Two beverage containers can be placed into the cup holder.
In the front area of the holder
A
one hand by pushing the container into the holder and turning the lid.
WARNING
Do not use breakable cups or beakers (e.g. glass, porcelain). This could
■
lead to injuries in the event of an accident.
Never put hot beverage containers in the cup holder. If the vehicle moves,
■
they may spill – risk of scalding!
on page 90 first.
» Fig.
on page 90 first.
and in the rear arm-
A
, a beverage container can be opened with
97.
Advertisement
Table of Contents
