Table of Contents
Advertisement
Armrest setting
Read and observe
on page 83 first.
›
To adjust the height, lift the armrest in the direction of the arrow
of the locking positions
» Fig.
83.
›
To close, lift the armrest in the direction of arrow
fold down again.
›
To Set the armrest lengthways in the direction of arrow
sired position.
Rear seats
Seat backrests
Fig. 84 Fold the seat backrest forwards from the interior/pull the belt
for the side trim
86
Operation
Fig. 83
Adjust armrest
A
into one
past the stop and then
A
Move to the de-
B
Fig. 85 Fold the seat backrest forwards from the luggage compart-
ment: version 1 / version 2
Before folding the seat backrests forwards, adjust the position of the front
seats in such a way that they are not damaged by the seat backrests. If neces-
sary, remove the rear head restraints
Folding forwards from the passenger compartment
›
Push the release lever
in the direction of arrow
A
backrest in the direction of arrow
In the undivided seat back, press the release handles
seat back at the same time.
Fold forward from the luggage compartment
On vehicles with a net partition, the left and then the right and middle rear seat
backrest must first be unlocked. The net partition must be rolled up in the
housing.
›
Pull the corresponding lever in the direction of the arrow
spective seat backrest is unlocked or folded forward.
Folding backwards
›
Pull the seat belt
for the side panel in the direction of arrow
C
›
Raise the seat backrest against the direction of arrow
handle
audibly locks. Check this by pulling on the seat backrest.
A
›
Make sure that the red pin
is hidden.
B
In the undivided seat back, pull the two outer belts to the side panel. After
folding back the backrest, the release handles
place on both sides of the backrest and the red mark
on either side of the backrest.
» page
88.
and fold down the seat
1
» Fig.
84.
2
on both sides of the
A
» Fig.
85. The re-
» Fig.
3
until the release
2
A
should audibly click into
should not be visible
B
84.
Advertisement
Table of Contents
