Table of Contents
Advertisement
2nd step - applies to both key versions
›
Grip the tow bar below the protective cap.
›
Push release pin
in the direction of arrow
C
ously push operating lever
in the direction of arrow
D
» Fig.
299.
Operating lever
remains locked in this position.
D
Check the setting of the standby position
Fig. 300 Standby position: key version 1 / key version 2 / position of the
lever and the release bolt with two key versions
Read and observe
on page 250 first.
Correctly adjusted standby position
Applies to key version 1 - the red marking on key
Applies to key version 2 - the eye of the key
Operating lever
is locked in the lower position.
C
The trigger pin
can be moved.
D
In the ready position, the key cannot be removed or turned into a different po-
sition. The ball bar is thus set ready for installation.
252
Driving
to the stop, and simultane-
3
to the stop
4
» Fig. 300
A
is pointing upwards.
is pointing upwards.
B
Assembling the bar ball – Step 1
Fig. 301 Insert ball rod / trigger bolt in the extended state
Read and observe
on page 250 first.
Insert ball rod - applies to both key versions
›
Remove the cover for the mounting recess
tion» Fig. 297
on page 251.
›
Adjust the ball rod to the ready position
tion.
›
Grip the tow bar from underneath
recess in arrow direction
until you hear it click into place
1
The lever
A
automatically turns upwards in the direction of arrow
release pin
pops out (both its red and green parts are visible)
B
If lever
does not turn automatically, or if the release pin
A
out, remove the ball rod from the mounting recess by turning lever
wards as far as it can go. Clean the contact surfaces on the ball rod and the
mounting recess.
WARNING
Keep your hands outside the lever's range of motion when attaching the
■
ball rod – risk of finger injuries!
Never attempt to pull the operating lever violently upwards to turn the
■
key. Doing so would mean the ball rod is not attached correctly!
in a downwards direc-
4
» page
251, Adjusting the ready posi-
» Fig. 301
and insert into the mounting
»
.
2
»
.
does not pop
B
A
and the
down-
Advertisement
Table of Contents
