Table of Contents
Advertisement
›
Screw the tail lamp into place and install the cover. The cover must engage
securely.
›
Shut the boot lid.
CAUTION
Ensure that the cable bundle does not become stuck between the body and
■
the lamp when it is being refitted – or there is a risk of damage to the electrical
installation and risk of water ingress.
If you are not sure whether the cable bundle has become pinched, we rec-
■
ommend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing the bulbs in the tail lamp assembly - Variant 1
Fig. 363 Outer part of the lamp/holder with bulbs
Read and observe
and
›
Unscrew the lamp holder
» Fig. 363
kit, and remove the lamp holder from the light assembly.
›
Turn the respective light bulb counter-clockwise to the stop and remove it
from the bulb holder.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Insert the bulb holder into the light and screw in.
on page 299 first.
with the screwdriver from the car tool
Replacing the bulbs in the tail lamp assembly - Variant 2
Fig. 364 Outer part of the lamp/Remove holder with bulb
Read and observe
and
›
Turn the holder with the bulb
A
›
Remove the socket with the bulb from the lamp housing in the direction of
arrow
.
2
›
Push the faulty bulb into the holder, turn in anti -clockwise direction up to
the stop and remove.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Reinsert the holder with the bulb into the lamp housing and turn in the oppo-
site direction of the arrow
to the stop.
1
on page 299 first.
in the direction of arrow
» Fig.
1
Fuses and light bulbs
364.
303
Advertisement
Table of Contents
