Table of Contents
Advertisement
›
Remove the key in the direction of the arrow
›
Turn the holder with the bulb to the stop in the direction of the arrow
›
Remove the holder with the bulb in the direction of arrow
›
Insert a new holder with the bulb in the headlamp and turn it in the direction
of arrow
as far as the stop.
6
›
Fit the connector.
Refit the headlight and cover
›
Replace the fog light by inserting it in the opposite direction of the arrow
» Fig. 360
and tighten.
›
Insert the guard and push it gently until it locks into place.
Removing/installing tail light
Fig. 361 Removing lamp
1)
The position of the opening may vary depending on the vehicle model.
302
Do-it-yourself
.
5
.
6
.
7
3
Fig. 362 Connector removal variants
Read and observe
and
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel trims into opening
» Fig.
361.
›
Remove the cover by pulling the hook in the direction of arrow
›
Unscrew the screws
with the key from the tool kit.
B
›
Hold the light and carefully remove in the direction of arrow
›
Remove connector
.
C
Remove the plug
The connector type varies according to the vehicle version
›
For connectors with lateral safety tabs, push these in the direction of arrows
or
and remove the connector carefully.
A
B
›
For connectors with removable safety tabs
arrow
, press the safety tabs in the direction of arrow
1
connector carefully.
Fitting
›
Insert the connector into the light and lock it securely.
›
With a plug with removable safety tab, secure this in the opposite direction
to the arrow
» Fig.
362.
1
›
Insert the lamp with pins
» Fig. 361
D
›
Carefully push the cover in
»
on page 299 first.
.
2
» Fig.
362.
, pull these in the direction of
C
and remove the
2
into the recesses
in the body.
E
.
A
1)
.
1
Advertisement
Table of Contents
