Table of Contents
Advertisement
All seats occupied, boot loaded
Driver seat occupied, boot loaded
In the event of another vehicle loading condition, the setting for positions . .
can be used.
The Xenon headlights feature no manual headlight range control. After
switching on the ignition, adjust these automatically to the load and driving
condition of the vehicle.
WARNING
Always adjust the headlight range control to comply with the following
conditions and prevent accidents.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Note
If, with a dipped beam, the ignition is turned off, then the dipped beam will
■
automatically switch off and the parking lights will come on. Does not apply to
the position , as long as the conditions are met for the COMING HOME
function . The parking lights are switched off when the ignition key is removed
(for vehicles with the KESSY system, after opening the driver's door).
If there is a fault in the light switch, the low beam comes on automatically.
■
Daytime running lights
The daytime running light (hereinafter referred to as "function") lights the
front and rear vehicle area (only valid for some countries).
The lights are switched on automatically if the following conditions are
met.
The light switch is in the position or .
The ignition is switched on.
The function is activated.
Deactivating/activating
The function can be deactivated/activated in Infotainment in the menu
→ → Light.
72
Operation
WARNING
Always switch on the low beam when visibility is poor.
Note
The light can operate automatically under certain circumstances, even if the
light switch is in position .
Note
The setting (activation/deactivation) of the daytime running lights is stored
(depending on the Infotainment type) in the active user account for personali-
sation
» page
57.
Turn signal and main beam
Control stalk positions
Switch on the right turn signal
Switch on the left turn signal
Switch on main beam (spring-tensioned position)
Switch on main beam or headlight flasher (spring-loaded position)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be used even if the ignition is switched off.
The turn signal switches off automatically depending on the steering angle af-
ter turning.
Use the control stalk to switch on/off the headlight
/
Comfort flashing
When the control talk is pressed slightly up or down, the respective turn signal
indicates three times.
Fig. 63
Control stalk: Turn signal/main
beam operation
» Fig. 63
assistant» page
74.
Advertisement
Table of Contents
