Table of Contents
Advertisement
Removing and installing the net partition housing
›
To remove, fold forwarded the rear seat backrests and open the rear right
door.
›
Push the housing
in the direction of the arrow
A
mountings in the direction of the arrow
›
To install, insert the recesses on the housing
rear seat backrests and push the housing against the arrow
stop.
›
Fold the rear seat backrests to their original position.
Transport on the roof rack
Fig. 147 Attachment points
112
Operation
Fig. 146
Removing the net partition
housing
and remove it from the
1
» Fig.
146.
2
into the mountings on the
A
up to the
1
Fig. 148 Remove the side panels of the luggage compartment/stow the
roof rack
Depending on the equipment, the roof bars can be attached at the attachment
points
» Fig. 147
or to the roof rail.
The attachment points
and
A
B
» Fig.
147.
Mounting and dismounting of the roof bars is carried out according to the in-
structions provided.
Roof load
The maximum permitted weight of the load incl. carriers is 75 kg.
Stowing the roof racks
With vehicles have the variable loading floor, then the roof racks can be stow-
ed in the recesses of the luggage compartment side trim.
›
Fold the variable loading floor into the upper position
›
Remove the side panels of the luggage compartment in the direction of ar-
rows
» Fig.
148.
1
›
Remove the key from the roof
›
Insert the front roof rack
into the front recesses of the side panel and the
A
rear roof rack
into the back recesses of the side trim.
B
›
Replace the side trims of the luggage compartment in the opposite direction
of the arrow
.
1
›
Fold out the variable loading floor to the upper position
are located on both sides of the vehicle
» page
110.
rack»
and stow in the recess
C
» page
109.
.
Advertisement
Table of Contents
