Table of Contents
Advertisement
Assembling the bar ball – Step 2
Fig. 302 Close lock: key version 1 / key version 2
Read and observe
on page 250 first.
Applies to key version 1
›
Turn key
in the direction of arrow
A
upwards
» Fig.
302.
›
Remove the key in the direction of the arrow
Applies to key version 2
›
Turn the key
in the direction of arrow
B
points down
» Fig.
302.
›
Remove the key in the direction of the arrow
Applies to both key versions
›
Fit and press cap
onto the lock in the direction of arrow
C
›
Check that the ball rod is securely attached
Fig. 303
Place cap on the lock
so that the green marking is pointing
1
.
2
so that the conclusions release
3
.
4
» Fig.
303.
5
» page
253, Check proper fitting.
WARNING
After fitting the tow bar, always secure the lock and remove the key. The
tow bar must not be operated with the key inserted.
Check proper fitting
Read and observe
on page 250 first.
Correctly secured tow bar
» Fig. 304
The tow bar must sit securely in the receiving shaft. There must be no play
when "shaken" roughly.
Operating lever
is as far up as possible.
A
The release pin
is completely exposed (both its red and green parts are
B
visible).
The key is removed and the cap
Removing the bar ball – Step 1
Fig. 304
Correctly secured ball rod
attached to the lock.
C
Fig. 305
Remove the cap from the lock
Towing device and trailer
253
Advertisement
Table of Contents
