Table of Contents
Advertisement
Route calculation and start route guidance
Route calculation is done on the basis of the set route options. The route op-
tions can be set: → Route options.
Alternative routes
With selection of alternative routes turned on, the following menu is displayed
after the calculation of a new route
- calculate the most economical route with the shortest driving time
A
and shortest distance travelled – the route is highlighted green
- calculate the fastest route to the destination, even if a detour is nec-
B
essary –the route is highlighted in red
- calculate the shortest route to the destination, even if a longer driving
C
time is required – the route is highlighted in orange
In the function surfaces of the alternative routes, information on the route
length and the estimated travel time and the following symbols are displayed
(applies to Infotainment Columbus).
Use of a toll motorway
Use of a train / ferry
Using a tunnel
Use of a toll road
Using a vignette duty highway
It is possible to select an already calculated alternative route before the calcu-
lation of the remaining routes is completed.
Selecting the type of route will start the route guidance.
If no route selection is made within 30 s after the calculation of all routes, the
route guidance is automatically started according to the preferred route type.
Fig. 227
Alternative routes
» Fig.
227.
Route calculation for the trailer
When driving with a trailer or any other accessory connected to the trailer
socket, we recommend that you switch on the trailer recognition, if necessary
to set the maximum speed for towing a trailer.
›
For calculating the route for towing a trailer, tap the function surface in the
main navigation menu → Route options → .
›
To set the maximum speed for towing a trailer, tap the
then the function surface → Driver assistance → Trailer recognition → Maximum
speed for trailer.
Demo mode
The Demo mode provides a travel simulation to the entered destination. The
function offers the option to travel through the calculated route "virtually".
When the Demo mode is turned on, a menu for route guidance in the Demo
mode or in normal operation is displayed before the start of route guidance.
›
To switch on/offin the main menu Navigation, tap on the function surface
→ Advanced settings → Demo mode.
When the Demo mode is switched on, the route starting point can be defined.
›
In the Navigation main menu, tap on function surface → Advanced settings →
Define demo mode starting point.
›
Define the starting point by entering the address or the current vehicle posi-
tion.
›
The demo mode starting point can also be set provided demo mode is turned
on by tapping on the desired map location and selecting the menu item Start
Demo Mode
» page
180, Entering a destination via the map point.
sensor field and
189
Navigation
Advertisement
Table of Contents
