Store route
In the area
, tap the function surface Save.
▶
A
▶
Save the edited route as a new route or replace the existing saved route.
The route is saved in the route list
Stop route guidance
▶
In the area
, tap the function surface stop .
A
Route change in the map
Only valid for Infotainment Columbus.
Fig. 230 Route change in the map / route transit point
A route in which no waypoints are contained, can be changed during route
guidance by adding a transit point.
Add a transit point
›
In the Navigation main menu, tap on function surface → Change route in map.
›
Touch the screen in the route field and move the cross-point to the desired
location on the map, e.g.
, move
A
The transit point
is added to the route
B
›
Tap on the function surface .
Then a route is recalculated and the route guidance starts.
Customise transit point
›
In the Navigation main menu, tap on function surface → Change route in map.
›
Touch the transit point
and move to a different location on the map.
B
›
Tap on the function surface .
Then a route is recalculated and the route guidance starts.
192
Infotainment
» page
192.
» Fig.
230).
» Fig.
230.
Remove transit point
›
In the Navigation main menu, tap on function surface → Change route in map.
›
Tap on function surface Delete waypoint.
›
Tap on the function surface .
Then a route is recalculated and the route guidance starts.
route list
In the route list, it is possible to create routes, save, delete, or start navigation.
New route
›
In the Navigation main menu, tap on function surface → Routes → New route.
Insert a route destination in one of the following ways.
›
Tap on the function surface Enter destination and enter a new destination.
›
or: Tap on function surface Destinations and select a destination from the list
of saved destinations.
›
To save the created route, tap the function surface Store.
›
Tap the function surface Startto start route guidance.
route import
The requirement for importing the route is that the Infotainment Online
» page 14
services are activated.
A route that has been created in the user profile on the ŠKODA Connect Portal
website and sent to the Infotainment system can be imported into the Info-
tainment memory even before switching on the ignition.
If the route was created with the ignition switched on and sent to Infotain-
ment, the route will only be imported from Infotainment after switching the
ignition off (for at least 15 minutes) and after switching it on again.
›
Switch on the ignition. When a new route is available, a message regarding
the option to import this route appears in the Infotainment screen automati-
cally.
If the user opts not to import the route immediately, the route can be impor-
ted manually later, as follows.
›
In the main Navigation menu, tap the function surface → Routes to check if
a new route is available.
›
or: tap on the
sensor field and then on the function surface → .
›
The function surface import routes Tap.