Table of Contents
Advertisement
If there is an obstacle, the closing process is stopped and the glass pane re-
tracts by several centimetres.
WARNING
If the tilting / sliding sunroof is closed, by pulling on the recess of the
switch in the direction of arrow
process is hindered by an obstacle, then at the third attempt at closing, the
force limitation will cease to function (if less than 5 s passes between the
individual attempts to close). The sliding/tilting roof closes with full force -
it may cause injury.
Convenience operation of the sliding / tilting roof
Read and observe
and
The convenience operation makes it possible to open or close the sliding/tilt-
ing roof using the key or the KESSY system via the sensor in the door handle
of the front door.
›
To open out, press and hold the button on the key.
›
or: Hold the key in the unlock position in the driver's door lock.
›
To close, press and hold the button (with KESSY, hold your finger on the
sensor on the outside of the door handle of the front door).
›
or: Hold the key in the lock position in the driver's door lock.
By interrupting the locking process, the closing operation is interrupted.
Activate operation of the sliding/tilting roof
Read and observe
and
If the operation of the sliding/tilting roof is deactivated (e.g. after disconnect-
ing and connecting the battery), then operation will have to be activated.
›
Turn on the ignition and set the switch to position
›
Press the switch on the recess E down and pull forwards.
The sliding/tilting roof opens/closes again after around 10 seconds.
›
Release the lever.
70
Operation
,
» Fig. 59
on page 69 and the closing
2
on page 69 first.
on page 69 first.
» Fig. 59
on page 69.
Manually operated sunblind
Read and observe
and
›
To open, pull the handle in the direction of arrow
›
To close, pull the handle in the direction of arrow
Electrically operated sunblind
Read and observe
and
Operation of the sunshade
» Fig. 61
Open - by pressing (press again - sunshade stops moving)
Close - by pressing (press again - sunshade stops moving)
The sunshade can also be operated by pressing and holding the appropriate
button (starts movement of the sunshade) and releasing it when the sunshade
reaches the desired position.
Fig. 60
Operation of the sunshade
on page 69 first.
A
» Fig.
60.
.
B
Fig. 61
Button for operating the sun-
shade
on page 69 first.
Advertisement
Table of Contents
