Table of Contents
Advertisement
Infotainment display
›
In Infotainment in the menu
Screen display
» Fig. 44
Distance travelled
A
Driving time
B
Average speed
C
Average fuel consumption
D
Transit point rating (DriveGreen Function)
E
Graphic fuel level display (if the estimated range is less than 300 km, the
F
vehicle starts to approach the symbol )
G
Approximate range (for vehicles with CNG drive, the approximate range
with petrol and CNG is displayed separately).
Use the function surfaces to select one of the following preset lists.
Since start - Driving data for the individual trip
▶
▶
Long-term - Long-term journey data
▶
Since refuel - Data since refuelling
Warning when exceeding the set speed
The system offers the possibility to set a speed limit beyond which an acoustic
warning signal will sound and the following warning message appears in the
display of the instrument cluster.
Adjust the speed limit while the vehicle is stationary
›
Select the menu item Warning at at () or () and confirm.
›
Set the desired speed limit is 5 km/h steps.
›
Confirm the set value, or wait several seconds; your settings will be saved
automatically.
Fig. 44
Journey data
/ Tap on function surface → Driving data.
Adjusting the speed limit while the vehicle is moving
›
Select the menu item Warning at at () or () and confirm.
›
Drive at the desired speed.
›
Confirm the current speed as the speed limit.
The set speed limit can be manually adjusted later if needed.
Reset the speed limit
›
Select the menu item Warning at at () or () and confirm.
›
By confirming the stored value, the speed limit is reset.
The speed limit set mode is stored even after the ignition is switched off and
on. After a gap between driving exceeding 2 hours, the pre-set speed limit is
deactivated.
Memory
The system saves the data in the three memories described below which are
displayed at the position
» Fig.
A
Since start ( ) Or "1" ( )
In the memory, driving data is saved for the time between switching on and
switching off the ignition. New data will also flow into the calculation of the
current driving information if the trip is continued within 2 hours after switch-
ing off the ignition.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
Long-term ( ) And "2" ( )
The memory gathers driving data from any number of individual journeys up to
a total of 99 hours and 59 minutes driving time or 9999 kilometres driven.
Fig. 45
Memory display: MAXI DOT dis-
play () / segment display ()
45.
Information system
53
Advertisement
Table of Contents
