Section 4
Service
Change HEPA Filter
If the Shaker Will Not
Spare Fuses
4-2
Orbital Shaker
The HEPA filter is located on the left side of the chamber, and is accessed
by pulling up the four black press-in fasteners and sliding the cover off.
Refer to Figure 4-1.
Instrumentation
Port
Press-in
Fasteners
HEPA Filter
Access Cover
(
Figure 4-1. HEPA Filter and Temperature Sensors Locations
Operate
If the shaker platform won't operate with the unit plugged in and the
power switch turned on, the following conditions may be present:
•
The lid is open. Lower the lid to its fully closed position.
•
Time countdown has been reached. Reset the time, or change to
continuous operation (Hold).
Three spare fuses are provided with this shaker and are taped to the
underside of the control panel plastic frame. The plastic frame is attached
to the cabinet by Velcro strips. Grasp the frame by the corners and pull to
remove. There are also small indents located along the edges of the panel
to accommodate a flat screwdriver blade. Figure 4-2 illustrates the
underside of the frame.
Figure 4-2. Spare Fuse Location
)
Press-in
Fasteners
Temperature Sensors
(Access Cover)
Thermo Scientific