Power Cord Assembly; Lead Wire Assembly - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(9) Power Cord
assembly
(10) Lead wire
assembly
Repair Procedures Description in
1
Remove the power cord wire from the hook of the
top cover.
2
Remove the back cover following the procedures
stated in
3
Remove the power cord while pinching the both
sides of the cord bushing with pliers and pressing
the tabs.
(Photo 32)
Note 1) When reassembling, bring the tab of the
Note 2) When reassembling, arrange the power cord
1
Open the control panel following the procedures
stated in
2
Remove the connectors (5 pcs) of the lead wire unit
from the Pc board assy.
(Photo 33)
3
Remove the connectors (1 pcs) of the lead wire unit
from the reed switch.
(Photo 34)
4
Remove the back cover following the procedures
stated in
5
Remove the lead wires of the safety switch following the
procedures state in
6
Remove the lead wires of the water intake valve
following the procedures state in
7
Remove the lead wires of the water level sensor
following the procedures state in
– 4 –
1 3
~
of (5).
Observe the followings when reassembling.
power cord bushing to the right side viewing
from behind the product.
wiring as it originally was.
1 6
~ in (1).
1 3
~ of (5).
1
of (6).
shows notes.
(Photo 32)
(Photo 33)
(Photo 34)
4
of (5).
1
of (7).