Drive Assembly; Clutch Assembly; Lever Assembly - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(18) Drive
assembly
Clutch
assembly
Lever
assembly
Repair Procedures Description in
Note 1) Make sure that the power cord is unplugged.
1 Remove the packing metal and rotor following the
2 For clutch assembly, remove 2 hexagon bolts
(Photo 6)
3 After pushing the hexagon bolt mounting position
4 For lever assembly, remove the stator following the
(Photo 69)
Note 1) Mount the clutch lever before mounting
(Photo 7)
Note 2) When mounting the clutch assembly to the
Note 3) Before mounting the rotor, make sure that
Note 4) Lock gear is not available just by itself as
– 5 –
procedures stated in 1~4 of (15).
(opposite side 8mm) that locks the switching lever.
on the switching lever, from which the hexagon
bolts were removed, to the lever assembly side,
remove the switching lever upwards and remove
the clutch assembly and clutch spring.
procedures stated in 5 of (15). Remove the snap
pin located at the tip of the clutch shaft and the
lever spring of the clutch lever. Then, remove the
lever and lever spring by pulling them towards you
simultaneously.
Observe the followings when reassembling.
the stator and clutch assembly. Clutch
lever cannot be mounted if the stator and
clutch assembly have already been
mounted.
spin shaft, mount the clutch spring first and
then the switching lever assembly. The
switching lever assembly must be mounted
by fitting and pushing the teeth of the clutch
assembly to the teeth of the lock gear.
the teeth of the clutch assembly, after
tightening the switching lever with a screw,
can be removed from the teeth of the lock
gear when the clutch lever is pulled.
precise mounting is required. Use
mechanical part assembly or cup assembly.
shows notes.
(Photo 6)
(Photo 69)
(Photo 7)