Pulsator - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(15) Motor
Stator coil
assembly

(16) Pulsator

Repair Procedures Description in
Observe the followings when reassembling.
Note 1)
Note 2) Be careful not to damage the coil or terminal
Note 3) Tighten the stator and rotor securely.
Tightening torque of the stator mounting bolt: 60~80kgf.cm
(
(Photo 58)
Tightening torque of the rotor mounting bolt: 250~350kgf.cm
Note 4) Be careful not to allow the rotor to be pulled to
Note 5) To mount the stator coil assembly, loosen the
(Photo 59)
(Photo 60)
(Photo 61)
1 Remove the cap of the pulsator(1pc) with a flat tip
2
(Photo 62)
– 5 –
Insert each of 4 connectors into the terminal
block by matching colors.
block with a tool to avoid insulation
deterioration.
the stator due to magnetic force of the rotor,
which could result in your hand pinched
between the rotor and stator.
hexagon bolts that locks the stator (6 pcs). Insert
the rotor setting jig into the shaft (the groove of
rotor setting jig must be to due position of four
hexagon bolts on the spacer a both, except
hexagon bolts position middle on the spacer).
Then insert stator plating jig into the groove of
the rotor setting jig. $LU JDS EHWZHHQ VWDWRU FRLO
assy and rotor assy is 0.4 mm)
Thighten the four hexagon bolts, then take out
the rotor setting jig from the shaft. Thighten the
two hexagon bolts position middle on the
spacer.
Then insert the rotor into the shaft and fix the
rotor with hand. Insert the hexagon wrench
(opposite side 4 mm) to the hexagonal hole in
the center of the shaft, then insert the rotor into
the end of the shaft while rotating the wrench.
screwdriver,etc.
Loosen the screw and UHPRYH WKH SXOVDWRU ZKLOH
holding the pulsator VFUHZ 'R QRW UHPRYH WKH
screw from the pulsator.)
shows notes.
)
(Photo 58)
(Photo 59)
(Photo 60)
(Photo 61)
3KRWR 
(Photo )