Geard-Motor - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(12) Geard-
motor
(Photo 44)
(Photo 45)
(Photo 46)
(Photo 47)
(Photo 48)
(Photo 49)
Repair Procedures Description in
1 Remove the rear cover. (6pcs screw)
2 Remove the cord holder and remove the connector
of the drain valve motor (3P) from the wirings in the
external case (inside the taping bundling the lead
wires : Lead wires in the top cover and lead wire
connectors on the main unit side). (Connector color:
Blue, Lead wire color: Brown, red, white)
* Lay down washing machine following the procedures
stated below.
• Before laying down washing machine, check
remaining water. If water remains, drain water by
pulling the drain valve connector.
• Remove the softener case and put a towel, etc. in
the water dispenser case before laying down the
main unit.
3
Remove the hook (screw, 1pc) which fixes the lead
wires on the water tub and remove the taping
bundling the lead wires. Then separate only the lead
wire of the drain valve motor from other lead wires.
4
Remove the valve spring from drain valve connector
with long-nose pliers.
5
Remove the mounting screws (2pcs) to remove the
drain valve motor.
Observe the followings when reassembling.
• Return the lead wire tape. Don't add the extra tape.
• Put the lead wire of the drain valve motor through the
air trap of the water tub and the hook on the valve
assembly, then fix it on the water tub together with
other lead wires.
• Check the height of the lead wire after assembling.
– 5 –
shows notes.
(Photo 44)
(Photo 45)
(Photo 46)
(Photo 47)
(Photo 48)
(Photo 49)