Table of Contents
Advertisement
Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name
Illustration
(15) Motor
Rotor
assembly
(15) Motor
Stator coil
assembly
Repair Procedures Description in
Note 1) Make sure that the power cord is unplugged.
1 Lay down the washing machine to the front side.
Before laying down washing machine, check
remaining water. If water remains, drain water by
pulling the drain valve connector.
Remove the softener case and put a towel, etc. in
the water dispenser case before laying down the
main unit.
(Photo 55)
2 Remove the connector 1P (3pcs) and 6P (1pc) that
3 Remove 3 tapping screws (opposite side 10mm)
4 Hold the rotor by hand and remove the hexagon nut
(Photo 56)
Note 1) When the rotor is difficult to come off, be
Note 2) Be careful not to allow the rotor to be pulled to
Note 3) Be careful not to lose the nut and washer.
Note 4) Do not insert a screwdriver into the hole on the
1
Note 1) Wear the gloves to avoid any possible danger
(Photo 57)
– 5 –
are inserted into the terminal block of the stator.
and packing metal.
(opposite side 17mm) to remove the rotor.
careful not to injure yourself by applying a
large force.
the stator due to magnetic force of the rotor,
which could result in your hand pinched
between the rotor and stator.
rotor. Contact with the stator could result in
electrical shock or insulation deterioration due
to damage on the stator.
Remove 6 hexagon bolts that locks the stator
(opposite side 10mm) to remove the stator.
when removing the stator.
shows notes.
(Photo 55)
(Photo 56)
(Photo 57)
Hide quick links:
Advertisement
Table of Contents
