Pc Board Assembly - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(1) Pc board
assembly
Repair Procedures Description in
• Eliminate static electricity before replacing the Pc board
assy as it may be damaged by static electricity.
• Use protective gears such as gloves when carrying
out disassembling or inspection.
<Cautions for repair and replacement> Refer to Page
4.
Follow the cautions on Page 4 for handling of spare
electronic components.
(Photo 1)
1 Open the lid and remove the cap of the panel assy
(2 pc) with a flat tip screwdriver, etc.
2
Remove the screw (2 pc) under the cap.
3
Pull up the top cover deco(2 pc) and slide down.
Remove the top cover deco (2 pc) from the top cover.
4
Slide the panel assy to back side and pull up the
panel assy from the top cover.
(Photo 2)
5
Remove the screw(4 pc) on the control panel.
6
Pull up the control panel from the top cover and raise
7
Remove the connectors (8 pcs) of the lead wire unit
from the Pc board assy.
8
Remove two tapping screws. Take out the Pc board
assy from the control panel.
(Photo 3)
Observe the followings when reassembling.
(Photo 4)
Note 1) Fit in the connector securely.
Note 2) Match the color of each lead wire.
Note 3) Do not pinch lead wires at any part where
Note 4) Do not pinch lead wires between the top cover
(Photo 5)
(Photo 6)
– 4 –
it towards you.
pinched lead wire can become an obstacle to
switch operations.
and control panel.
shows notes.
(Photo 1)
(Photo 2)
(Photo 3)
(Photo 4)
(Photo 5)
(Photo 6)