Symptoms That Are Easily Suspected As Failure - Toshiba AW-SD150SBA Service Manual

Symptoms That Are Easily Suspected As a
Failure
Symptom
(1) Error is displayed Check following "Abnormality Alarm" on Page 2 ~ 2.
on the timer display
and electronic
buzzer sounds.
1 Is "Abnormality Alarm" mentioned on the above (1)
(2) Operation stops
in the midst of a
made?
process.
2 Has the process where spinning is omitted been set?
If the process where spinning is omitted is set, the
operation stops at the completion of the final rinse
without performing draining.
1 Is the "START/STOP" button pressed after laundry
(3) "WASH, RINSE
and SPIN" buttons started?
do not work when
2 Is a change made in the midst of rinse or spin
a process is under
process?
way.
(Rinse and spin process cannot be changed in the midst
of the process.)
(4) "START/STOP" Has the timer been set?
button does not
work.
1 Has the process where spinning is omitted been set?
(5) Water cannot be
drained effectively.
2 Is the drain hose raised
Water cannot be
due to a doorsill, etc.?
drained.
(Is the abnormality alarm
It is difficult to
"E1" made?)
drain the water.
(E1 is displayed.)
3 Is the drain hose raised
due to a doorsill, etc.?
(Is the abnormality alarm
"E1" made?)
4 Is a commercially available
thinner hose (25 ) used
as an extension of the
drain hose?
(Is the abnormality alarm
"E1" made?)
5 Is the drain hose connected
to the drain port without any
gap? (Is the abnormality
alarm "E1" made?)
Check Points
Height
Length
Diameter is small.
– 3 –
Actions to be Taken
Take actions stated on
"Abnormality Alarm" on
Page 2 ~ 2.
Same as the above (1).
Use the machine just by
pressing the COURSE
button only. Automatic
operation will be performed
from washing until
spinning.
Do the setting after
pressing the START button.
It is not a failure. When
wanting to make any
change in the midst of a
process, press the power
switch to turn off and on
the power and then do the
setting again.
It is not a failure. Press the
power switch to turn off
and on the power and then
cancel the timer.
Same as the above (2) -2
Adjust the height of the
drain hose to 15cm or
below.
Adjust the length of the
drain hose to 3m or below
(on a flat surface).
Replace the extension to
the optional extension
hose designated by
Toshiba
Allow some gap.
Gap 3cm
Gap
and above