Drain Valve - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration

(13)Drain Valve

Repair Procedures Description in
1
Remove the rear cover. (6 pcs screw)
2
Lay down the washing machine to the front side.
• Before laying down washing machine, check
remaining water. If water remains, drain water by
pulling the drain valve connector.
•
Remove the softener case and put a towel, etc. in
the water dispenser case before laying down the
main unit.
(Photo 50) 3
Remove the valve spring from drain valve connector
with long-nose pliers.
4
Remove the valve cap by turning it counterclockwise.
At this time, put a towel, etc. under the valve so that
water flown out from the valve will not wet the motor.
Observe the followings when reassembling.
Note 1) Firmly tighten the valve cap as loose valve
– 5 –
cap may cause water leakage.
shows notes.
(Photo 50)