Water Level Sensor - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(6) Safety lever
5 
±
(7) Water level
sensor
(Photo 26)
Repair Procedures Description in
* Following notes are necessary when reassembling.
Note 1: Make
Note 2 : Taking care not to miss the color of each lead
(Fig. 2)
1
Remove the connector from the water level sensor.
(Photo 24)
2
Pull up the water level sensor with pushing hooks.
(Photo 25)
3
Pull out the air tube from the water level sensor.
Note : When reassembling the DLU WXEH DUUDQJH WKH
– 4 –
sure (through the half hole provided
on upper frame) distance between the safety
lever and the cabinet is 5 ±mm. (Fig. )
wire and connectors. Also make sure they are
connectors. Also make sure they are
connected securely. The intake valve has
specified lead colors.
Observe the followings when reassembling.
packing its by apply adhesives for connection
type "CEMEDINE 366E".
shows notes.
(Photo 24)
(Photo 25)
(Photo 26)