Notes on Installation
About operation check during installation
1. Wash operation check
Plug in the power cord and press the "POWER" button. Then, press the "START" button.
Pulsator rotates clockwise and counterclockwise direction. Detergent amount 0.2 cup is displayed.
Knocking sound is heard when plugging in. However, it is not abnormal.
2. Spin operation check
Close the lid and press the "POWER", "SPIN" and "START" buttons in this sequence.
Before spinning starts, the wash tub rotates slowly and a clicking operation sound is heard because
the clutch is switched from washing to spinning.
The brake works at the completion of spinning. Then the wash tub rotates and the clutch switching
from spinning to washing is performed.
For the course operation, the clutch switching from washing to spinning and vise versa will be
performed automatically.
NOTE
Never do as shown in the drawing below.
About Error Display
When the following errors are displayed, carry out the inspection stated below.
If the error is not solved even after the above inspection, please request repair service.
6. CHECKING PROCEDURES
Direct insertion of the drain hose from
interior of the washing machine into the
drain hole could result in water leakage
or abnormal noise.
Is too much laundry put into the
tub?
Is the water level set to too low for
the laundry load?
– 2 –
Turn off and on the power. Reduce
the laundry or reset the water level
and then press the start button
again.