Valve Assembly - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(14) Valve
Assembly
(Photo 52)
Repair Procedures Description in
Note 1) Make sure that the power cord is unplugged.
1
2
•
•
(Photo 51)
3
4
5
Remove the tapping screw (3 pcs) to remove the
valve assembly from the tub.
Observe the followings when reassembling.
Note 1) Make sure to attach packing (O-ring) to the
(Photo 53)
Note 2) When putting the inner hose, set the position
Note 3) Apply adhesives for connection of drain hose.
Note 4) After replacing the valve assembly, make sure
(Photo 54)
Note 5) Fix the hose band to the original position.
– 5 –
Remove the rear cover. (6 pcs screw)
Lay down the washing machine to the front side.
Before laying down washing machine, check
remaining water. If water remains, drain water by
pulling the drain valve connector.
Remove the softener case and put a towel, etc. in
the water dispenser case before laying down the
main unit.
Remove the upper side of the overflow hose with a
cutter knife from the tub.
Remove the hose (rubber) with a screwdriver (-) from
the valve assembly.
tub before mounting the valve assembly to the
tub. Check the O-ring shape.
marking of the inner hose to the marking of the
drain valve.
When applying adhesives, be careful not to
allow the adhesives go in the water flowing
part.
to check that no water leaks by filling the tub
with water.
shows notes.
(Photo 51)
(Photo 52)
(Photo 53)
(Photo 54)