Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name
Illustration
(4) Reactor
(5) Water intake
valve, Water
feed case
assembly
Repair Procedures Description in
2
Take out the connector from Pc board assy.
3
Remove the reactor while opening the hook(2 places).
(Photo 12)
Note 1) When cutting the insulock, don't damage the
Note 2) When reassembling, arrange the lead wires
(Photo 13)
1 Remove the softner case.
(Photo 14)
2 Remove 2 back cover mounting screws at rear.
(Photo 15)
3 Remove the back cover by inserting a screwdriver (-)
from the lower end of bottom.
(Photo 16)
– 4 –
Observe the followings when reassembling.
lead wire.
as it originally was.
shows notes.
(Photo 12)
(Photo 13)
(Photo 14)
(Photo 15)
(Photo 16)