Abnormality Alarm; Error Display And Description Of Abnormality Alarm - Toshiba AW-SD150SBA Service Manual

Abnormality Alarm

(1) Error display and description of abnormality alarm

In case of abnormality or failure such as incorrect operation and faulty drainage or spinning, the operation is
stopped by error display and abnormality report (buzzer alarm).
Error Display
After starting draining in wash or spin process, the water level does not
go down below the reset level even after the specified time has elapsed.
(To be detected by the water level sensor) [7 mins 30 secs]
Occurred by drain hose that was not put down or flattened hose, etc.
Abnormal
drainage
The lid is open or opened during spin in rinse and spin process or during
shower rinse operation. (To be detected by the lid switch)
(E21):The lid is opened, while spining or switching of clutch.
Abnormal
(E23):The lid lock is not locked or is not released.
open lid
E21, E23
Unbalance occurred by uneven laundry load during the final spinning.
Unbalance detected t rectifying operation was repeated but the
unbalance was not rectified.)
Abnormal
Abnormality alarm) When an unbalance was detected 3 times during the
unbalance
same spin process. In dry course, however, abnormality alarm sounds at
the first abnormality detection.
E31, E32
(E31): When abnormality was detected by the lid switch unbalance. (To be
detected by the lid switch)
(E32): When abnormality alarm was detected by the vibration sensor. (To
be detected by the rotation sensor.)
When the water level reaches the following water level during water supply
in wash and rinse process or while rectifying an unbalance, the water does
not rise up to the water level of one-level higher even after a specified time
Abnormal has elapsed. (To be detected by the water sensor)
water supply
Occurred by a tap which was not turned on or water supply valve failure,
etc.
Overcurrent flows through the motor while the motor is running (for all
processes).
(Current value flowing through the motor drive circuit is detected by the
program timer assy.)
Abnormal
Occurred by excessive laundry load, too low water level, defective wiring
motor current
between the motor and the program timer assy, motor drive circuit failure,
etc.
E61, E63~66
(E61): While washing (E63): Abnormality occurred while spinning and there
was no problem during washing.
(E64): Occurred when spin only is set. (E65): When clutch is switched to
washing.
(E66): When clutch is switched to spinning.
Description of Detected Error
Detected water level Detected time
97 ~ 105L 16 minutes
91 ~ 97L 12 minutes
82 ~ 91L 18 minutes
76 ~ 82L 12 minutes
69 ~ 76L 14 minutes
60 ~ 69L 18 minutes
55 ~ 60L 10 minutes
46 ~ 55L 18 minutes
36 ~ 46L 20 minutes
0 ~ 36L 52 minutes
– 2 –
How to Cancel
After opening and closing
the lid, press the start
button. The operation
resumes from the stopped
state.
(E21):Close the lid. The
operation resumes from
WKH stopped state.
( 7XUQ off and on the
SRZHU 2))ON)button.
Operation will not continue.
Start back the operation
from the begining again.
Open and close the lid.
The operation resumes
from the stopped state.
After opening and closing
the lid, press the start
button. The operation
resumes from the stopped
state.
Turn off and on the power
(OFF/ON) button.
Operation will not
continue. Start back the
operation from the
beginning again.