Cup Assembly; Spin Shaft Assembly - Toshiba AW-SD150SBA Service Manual

Unless otherwise specified, reassembling is to be performed in the reverse procedures of disassembling.
Part Name Illustration
(19) Drive
assembly
Cup
assembly
Spin shaft
assembly
Repair Procedures Description in
Note 1) Make sure that the power cord is unplugged.
1 Remove the rear cover. (Screw 6pcs)
2 Remove the cord holder, then remove the wiring in
(Photo 7)
3 Remove the pulsator following the procedures
4 Remove the wash tub (wash spin tub) following
5 Remove the packing metal, rotor and stator
6 Remove 1 hook mounting screw to remove the
(Photo 7)
7 Separate only lead wire with tube that comes from
8 Remove the clutch assembly and lever assembly
9 Remove 6 hexagon bolts of the cup assembly
!
(Photo 7)
11
Note 1) After replacing the bearing mechanical part,
Note 2) When removing the mechanical part or
Note 3) Re-fix the removed lead wire securely to the
– 5 –
the external case (inside the tapping bundling : Lead
wires in the top cover and lead wire connectors on
the main unit side) and earth wire
( 4screw with plain washer).
stated in (16).
the procedures stated in (20).
following the procedures stated in (15).
lead wires.
the cup assembly from other lead wires wound with
vinyl tape.
following the procedures stated in (18).
(opposite side 12mm) to remove the cup assembly.
Remove the WDSSLQJ screw(2 pc)to remove the drain
valve motor following the procedures stated in ().
$QG remove internal earth wire(screw 1 pc). Remove
WKH screws(17 pc) of the tub reinforce plate to remove
WKH tub reinforcLQJ plate from the tub.
5HPRYH WKH spin shaft assembly from the tub.
Observe the followings when reassembling.
make sure to check that no water leaks by
filling the tub with water.
checking loosen screws, make sure to
remove the wash tub (wash spin tub).
If the above is not carried out, the wash tub
may incline.
lead wire through hole on the valve and
external case.
shows notes.
(Photo 7)
(Photo 7)
(Photo 7)