Direct Power On - Canon 4K600STZ User Manual

Menu Settings
Power management duration
Specify how much time must pass before the light source goes off or the projector enters
standby mode, depending on the [Power management mode] setting.
Option
5 min. - 60 min.
• If conditions that would start countdown are met while you are blanking projection,
blanking is canceled.
• Once countdown begins, audio output stops.

Direct power on

You can turn on the projector by connecting the power cable without pressing the POWER
button.
Option
Off
On
• Before enabling direct power on, be sure to set [Power management mode] to an
option other than [Disabled]. When [Disabled] is selected, [Direct power on] is not
available.
• The projector is also equipped with a Direct Power Off feature. No damage is caused
to the projector even if it is unplugged during projection to turn it off without pressing
the POWER button. However, setting adjustments made immediately before
unplugging the projector may not be stored.
Motion blur reduction
> [System settings] >
Motion blur is blurring that occurs during video playback. Motion blur reduction can
make this blurring less noticeable.
Option
Off
Weak
Strong
• If setting the projector to [Strong] or [Weak] produces distracting flickering, set it to [Off].
• [Motion blur reduction] is not available in [DICOM SIM] image mode. The menu is
grayed out.
After 30 seconds without an input signal when the projector is idle, the
projector starts displaying a countdown of the selected time.
The POWER button must be pressed to turn the projector on.
You can turn on the projector by connecting the power cable only.
[Motion blur reduction]
Motion blur reduction is not performed.
Reduce motion blur for fast-moving images. Note that images may
be slightly darker, and flickering may occur.
Reduce motion blur for images moving faster than with [Weak].
Note that images may be darker, and flickering may occur.
126
Function
Function
Function