Specifying Power Management Duration; Specifying Direct Power-On - Canon WUX6000 User Manual

Specifying Power
Management Duration
> [System settings] >
management duration]
HDMI
Digital PC
Specify how long before the lamp is
turned off or the projector enters
standby, depending on the [Power
management mode] setting.
5 min. -
60 min.
Press the OK button to accept your
setting and then press the MENU
button.
• [15 min.] is the factory default.
• If conditions that would start countdown are
met while you are blanking projection,
blanking is canceled.
• Once countdown begins, audio output
stops.
Downloaded From projector-manual.com Canon Manuals
Customizing System Operation (System Settings)
[Power
Component
Analog PC
After 30 seconds without an
input signal when the projector
is idle, the projector starts
displaying a countdown of the
selected time.
Once this time elapses without
an input signal and while the
projector remains idle, the
lamp is turned off or the
projector enters standby. (P98)
Specifying Direct
Power-On
> [System settings] >
on]
LAN HDMI
USB Digital PC
You can turn on the projector by
connecting the power cable without
pressing the POWER button.
Off You need to press the POWER button
to turn on the projector.
On You can turn on the projector by
connecting the power cable only.
Press the OK button to accept your
setting and then press the MENU
button.
• [Off] is the factory default.
• Before enabling direct power on, be
sure to set [Power management
mode] to an option other than
[Disabled]. When [Disabled] is
selected, [Direct power on] is not
available.
• After turning off the projector, wait at
least 5 minutes before turning it on
again. It may shorten the lamp life if
you turn on the projector
immediately after turning it off.
99
[Direct power
Component LAN
Analog PC USB