Direct Power On - Canon 4K500ST User Manual

Direct power on

> [System settings] >
You can turn on the projector by connecting the power cable without pressing the
POWER button.
Option
Off
On
• Before enabling direct power on, be sure to set [Power management mode] to an
option other than [Disabled]. When [Disabled] is selected, [Direct power on] is not
available.
• After turning off the projector, wait at least 5 minutes before turning it on again. It may
shorten the lamp life if you turn on the projector immediately after turning it off.
Motion blur reduction
> [System settings] >
Motion blur is blurring that occurs during video playback. Motion blur reduction can
make this blurring less noticeable.
Option
Off
Weak
Strong
• If setting the projector to [Strong] or [Weak] produces distracting flickering, set it to [Off].
• [Motion blur reduction] is not available in [DICOM SIM] image mode. The menu is
grayed out.
[Direct power on]
The POWER button must be pressed to turn the projector on.
You can turn on the projector by connecting the power cable only.
[Motion blur reduction]
Motion blur reduction is not performed.
Reduce motion blur for fast-moving images. Note that images may
be slightly darker, and flickering may occur.
Reduce motion blur for images moving faster than with [Weak].
Note that images may be darker, and flickering may occur.
115
Menu Settings
Function
Function