Direct Power On - Canon WUX500ST User Manual

Power management duration
> [System settings] >
Specify how long before the lamp is turned off or the projector enters standby,
depending on the [Power management mode] setting.
Option
5 min. - 60 min.
• If conditions that would start countdown are met while you are blanking projection,
blanking is canceled.
• Once countdown begins, audio output stops.
• This setting can also be adjusted from the power saver settings screen by pressing the
ECO button on the remote control.

Direct power on

> [System settings] >
You can turn on the projector by connecting the power cable without pressing the
POWER button.
Option
Off
On
• Before enabling direct power on, be sure to set [Power management mode] to an
option other than [Disabled]. When [Disabled] is selected, [Direct power on] is not
available.
• After turning off the projector, wait at least 5 minutes before turning it on again. It may
shorten the lamp life if you turn on the projector immediately after turning it off.
• The projector is also equipped with a Direct Power Off feature. No damage is caused to
the projector even if it is unplugged during projection to turn it off without pressing the
POWER button. However, setting adjustments made immediately before unplugging
the projector may not be stored.
Beep
> [System settings] >
You can select whether a beep sounds or not when you operate the projector.
Option
Off
On
The beep will not sound if you mute the projector sound with the MUTE button on the
remote control.
[Power management duration]
After 30 seconds without an input signal when the projector is idle,
the projector starts displaying a countdown of the selected time.
[Direct power on]
The POWER button must be pressed to turn the projector on.
You can turn on the projector by connecting the power cable only.
[Beep]
Disables the beep.
Enables the beep.
109
Menu Description
Function
Function
Function