Table of Contents
Advertisement
Menu Settings
Lens - Position
> [Install settings] >
The projector can store information about the lens position. Up to three sets of lens
information (including, focus, zoom, and lens shift settings) can be saved, and the
lens can be restored to these positions as needed.
Submenu
Restores the lens to the positions saved using [Save position 1] -
Load position 1-3
[Save position 3].
Save position 1-3
Saves the lens position as one of the available positions (1-3).
Lens shift reset
Restores the lens to the original position.
• When saved lens positions are restored, images may be slightly misaligned, relative to
the saved position.
• Specifying a somewhat smaller image size than the screen size (image area) enables
you to switch among multiple lens positions without the image extending off the screen.
• When precise positioning is needed, use lens shift, zoom, and focus functions to fine-
tune the position.
• [Save position] and [Lens shift reset] are not available when [Positional lock] is set to
[On] (P108).
• [Load position] is grayed out and not available unless positions have been stored to a
[Save position].
• The following setting values are stored: focus, zoom, lens shift, keystone, corner
adjustment, and screen color.
Screen color
> [Install settings] >
You can adjust the color quality of the images projected according to the color of
the projection screen.
Submenu
Select this if a standard type of projection screen is used. The images
Normal
are projected in a light quality similar to that of natural light.
Select if a dark green surface such as a blackboard is used as the
Greenboard
screen. The color quality similar to [Normal] is obtained on the
greenboard.
Adjust
Select to fine-tune the gain and offset of red, blue, and green.
[Lens - Position]
[Screen color]
116
Function
Function
Advertisement
Table of Contents
