Specifying Direct Power-On; Specifying Silence Or Operating Tones - Canon WX450ST User Manual

Specifying Direct
Power-On
> [System settings] >
on]
HDMI
Digital PC
You can turn on the projector by
connecting the power cable without
pressing the POWER button.
Off You need to press the POWER button
to turn on the projector.
On You can turn on the projector by
connecting the power cable only.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• [Off] is the factory default.
• Before enabling direct power on, be
sure to set [Auto power-off] to an
option other than [Disabled].
Selecting [Disabled] will prevent you
from using auto power-off.
• After turning off the projector, wait at
least 5 minutes before turning it on
again. It may shorten the lamp life if
you turn on the projector
immediately after turning it off.
Downloaded From projector-manual.com Canon Manuals
Customizing System Operation (System Settings)
[Direct power
Component LAN
Analog PC USB
Specifying Silence or
Operating Tones
> [System settings] >
HDMI
Digital PC
You can select whether a beep
sounds or not when you operate the
projector.
Off Disables the beep.
On Enables the beep.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
• The factory default is [On].
• The beep will not sound if you mute the
projector sound with the MUTE button on
the remote control.
111
[Beep]
Component LAN
Analog PC USB