Safety Precautions - Rimage Everest Encore User Manual

Important Information
Safety and Compliance Information
This manual and the indications on the product allow proper and safe
operation. The indication marks below help protect you and other persons
from injury, and equipment from damage.

Safety Precautions

To ensure safety, read these precautions and familiarize yourself with their
meaning before using the equipment.
ȸ Warning!
• Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiant exposure.
• Do not disassemble or use tools on the printer. All service procedures should
be performed by a Rimage-authorized technician, or sent in for Rimage-
authorized repair.
• Do not service the printer with the power cord plugged in the AC outlet.
• The interior of the printer contains sharp edges.
• The front bezel of the printer can be opened by hand. Do not insert your
fingers.
• Do not touch the heat roller.
ȸ
Country-specific cautions for Wideband Data Transmission
systems: 2400-2483.5 MHz
• France: Do not use outdoors.
• Italy: If used outside of own premises, general authorization is required.
• Norway: This subsection does not apply for the geographical area within a
radius of 20km from the center of NY-Alesund.
ȸ
Caution:
• All equipment with AC line voltage, or low DC voltages, such as switches,
power supplies, fuses, fans, and non-stepper motors, must be replaced with
Rimage-approved components to maintain the safety approval issued by
UL.
2004001_A
•
•
•
•
•
•
•
•
For more information visit www.rimage.com/support
Use only the supplied AC power cord. Fore more information or to order a
new power cord, contact Rimage Customer Service.
This product is designed for an office environment.
Do not use the printer if it is overheating or an abnormal smell is detected.
This may result in a fire and an electric shock. In case of heating or
abnormal smell, immediately disconnect the cable from the outlet. Contact
your Rimage-authorized dealer for repairs.
Allow sufficient free space for opening the printer tray. Do not touch the
printer tray while it is in motion.
If the side cover is opened while power is supplied, the printer will stop. Do
not reach into the printer while it is in operation. Do not attempt to bypass
the door interlock.
This printer has no power switch. Power is disconnected completely by
unplugging the cable. Rimage recommends installing the printer in a
position that allows immediate disconnection of the power cable. Always
hold the plug when disconnecting the cable from the outlet.
This printer has a voltage slide switch on the back of the unit. Before use,
check that is set to the correct voltage. Please do not use any voltage other
than 110VAC or 220VAC. This could result in a fire and an electric shock.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment
and receiver. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help.
3