Identifying The Parts Of The Everest Encore Printer; Front View; Control Panel; Control Panel Indicators - Rimage Everest Encore User Manual

Identifying the Parts of the Everest Encore Printer

This section describes the Everest Encore printer hardware and features.

Front View

Side Cover Latches
Side
Cover
Control
Panel
2004001_A

Control Panel

Handle

Control Panel Indicators

Control Panel Indicators
Image

Switches

Printer
Tray
There are two switches on the rear of the Everest Encore: the AC voltage
switch and the mode switch.

AC Voltage Switch

The AC voltage switch is used to select the AC voltage of the power outlet.
For more information visit www.rimage.com/support
The control panel is located on the front of the Everest Encore.
It includes an operator button and four indicator lights. (One
light is on the operator button.) The control panel allows you to
monitor and control the printer.
The table below identifies the name and function of all parts of
the control panel.
Name Function
Operator button The Operator button is used to
complete the following tasks:
• Open the printer tray
• Close the printer tray
• Reset after an error
• Put the printer into sleep
mode. To put the printer into
sleep mode, press and hold the
Operator button for 10 seconds.
To resume normal operation,
press the Operator button again.
Error indicator light The Error indicator light
(on the operator illuminates when operator action
button) is required.
Mode Switch
AC Voltage
Switch
8