Everest Encore Printer Requirements; Ribbon Requirements; Everest Encore Ribbons; Label Design Requirements - Rimage Everest Encore User Manual

Everest Encore Printer Requirements

This section describes ribbon, label design, and print requirements for the
Everest Encore printer.

Ribbon Requirements

Important!
Rimage only supports the use of Rimage brand ribbons in our printers.
•
Printer issues that occur as a result of using ribbons from manufacturers
other than Rimage are not included under your Rimage warranty or
maintenance agreement.
For optimum results, make sure that Everest Encore ribbons are stored
•
at a temperature between 41° and 95°F (5° to 35°C) and humidity level
between 45% and 85%.
Avoid moisture and direct sunlight.
•
Do not reuse ribbons.
•
Use only ribbons designed for the Everest Encore printer. Refer to the
•
table below.
The Everest Encore printer requires a print ribbon and a retransfer ribbon.
The standard print ribbon has three colors: Cyan, Magenta, and Yellow
(CMY). These three colors combine in printing to create full-color discs. Print
ribbons are also available in black.

Everest Encore Ribbons

Ribbon Type
3-Color (CMY)
Black (monochrome)
Retransfer ribbon (500 prints)
2001474_A
Number of Discs Printed
500
1000
500
For more information visit

Label Design Requirements

• Label design size – Design labels with a height of 12 cm and width of 12
cm. A full-size disc is 120 mm (4.723") in diameter. The hole is 15 mm
(0.59"). The printable area and hub sizes vary depending on the disc
manufacturer.
Tip: The media that are in Rimage Media Kits have a printable area of
118-24 mm. On most labels, print settings of 118 mm and 24 mm are
recommended.
Printable
Area 118 mm
• Color mode – If your Everest Encore is on a Rimage autoloader,
convert all labels to the RGB color mode in order to import them into
CD Designer. If the Everest Encore is a standalone printer or on an
AutoEverest AutoPrinter, and you are printing directly from an image-
editing program, you can work in the color mode of your choice.
• Resolution (pixels per inch) – For best results, use images set to a
minimum of 300 pixels per inch. You may notice better results if you use
images with 600 pixels per inch or higher.
rimage.com/support
Hub Size
24 mm
6