Rimage Everest User Manual

Rimage Everest Printer™ Unpacking Instructions
Remove the Everest printer and accessories
1
from the box.

Warning! Lift the
Everest printer with
Foam
care; it is very heavy.

Note: Keep
all packaging
Everest printer
materials.
Box
2
Move the shipping screw.
a. On the back of the Everest printer,
use a Phillips screwdriver to remove
the shipping screw.
b. Using a Phillips screwdriver, install
the shipping screw in the location
indicated by the caution card.
3
Open the Everest printer.
a. To open the side cover, press
the two cover latches and
lower the side cover.
b. Open latches 1, 2, and 3 as
indicated by the arrows.

4
Ribbons
User Guide
Foam
5
Cover latches
Side cover
Latch 
Latch 2 Latch 3
Remove the internal packing pieces.
a. Inside the Everest printer, remove the plastic packing pieces.
Install the print ribbon.
a. To remove the ribbon carrier,
grasp the ribbon carrier and pull
out.
b. Install the ribbon around the ribbon guides
and snap the ends of the ribbon into the
ribbon carrier.
Ribbon guides
c. To tighten the ribbon, turn the
takeup roller clockwise as
indicated by the arrow.
d. Insert the ribbon carrier into
the printer, but do not close the
latches.
6
Install the transfer ribbon.
a. To access the transfer ribbon
carrier, grasp the transfer ribbon
carrier and pull out.

Note: The transfer ribbon
carrier slides out from the
printer but remains attached.
b. Install the transfer ribbon
around the ribbon guides and
snap the ends of the ribbon
into the ribbon carrier.
c. To tighten the ribbon, turn the takeup roller clockwise as
indicated by the arrow.
d. Slide the ribbon carrier into the
printer.
e. Close latches 1, 2, and 3 as
indicated by the arrows.
f. Close the printer side cover.
7
Set the switches.
a. On the back of the printer, set the rotary switch so the
recessed line points to your equipment type. Refer to the
table below.
SW Equipment
0 Standalone printer
 Autoloader
Takeup 2 AutoPrinter
roller
b. On the back of the printer, set the voltage switch to match
the AC outlet voltage.
8
Learn more.
For more information about operating and maintaining the
Everest printer, refer to the Everest Printer User Guide included
with your product.
For autoloader or AutoPrinter information, refer to the
instructions included with your autoloader or AutoPrinter.
Transfer
ribbon carrier
Takeup
roller
Ribbon guides
Latch 
Latch 3
Latch 2
Rotary switch
0644_L