Table of Contents
Advertisement
Maintaining the Everest 600 Printer
Maintaining the Everest Encore Printer
c. Install the retransfer ribbon carrier.
d. Close all latches.
e. Close the side cover.
f.
Turn the mode switch to the correct operating position.
For more information, refer to the
g. Power on the printer.
The printer is ready for use.
Clean the Sensors
When should you clean the sensors?
•
You receive an error message stating that the printer is not detecting the print
ribbon.
•
You receive an error message stating that the upper sensor is not responding.
•
You receive an error message stating that the lower sensor is not responding.
•
The printing is off center.
Tools Required
#
•
Sponge swabs with long
handles (included in the
Everest cleaning kit)
•
Can of compressed air
1. Access the sensors.
a. Press the two side cover
latches to release the side
cover.
b. Lower the side cover.
c. Open latch 1.
2004001_A
Switches
section on page 10.
For more information visit
d. Remove the print ribbon carrier. For specific instructions, refer to
the
Remove the Print Ribbon
e. Remove the retransfer ribbon carrier. For specific instructions, refer
Remove the Retransfer Ribbon
to the
2. Power off the printer, autoloader or AutoPrinter. Refer to the
and Off the Everest Encore Printer
Important! Do not clean the printer sensors until the printer is
completely powered off.
3. Locate the sensors.
•
Print ribbon sensor
•
Upper sensor
•
Lower sensor
Print
Ribbon
Sensor
www.rimage.com/support
procedure on page 16.
procedure on page 19.
Power On
section on page 11 for instructions.
Upper
Sensor
Lower
Sensor
26
Advertisement
Table of Contents
