Clean The Rear Air Filter - Rimage Everest Encore User Manual

Maintaining the Everest Encore Printer Maintaining the Everest 600 Printer
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to clean tacky roller 1.
c. Use the sponge swab to remove any waxy buildup from other parts
of the ribbon carrier.
d. Install the print ribbon on the print ribbon carrier. Refer to the
Change the Print Ribbon
procedure on page 16.
3. Inside the printer, use the sponge swab to wipe tacky roller 2.
4. Prepare the printer for use.
a. Install the print ribbon carrier.
b. Close all latches.
c. Close the side cover.
The printer is ready for use.
2004001_A

Clean the Rear Air Filter

#
1. Remove the air filter.
Tacky
Roller 2
2. Clean the air filter.
3. Prepare the printer for use.
The printer is ready for use.
For more information visit www.rimage.com/support
Tool Required: Phillips #2 screwdriver
Fan Cover
a. At the rear of the printer, remove the Phillips screws (Qty. 2) that
secure the fan cover.
b. Remove the fan cover.
c. Remove the air filter.
a. Hold the air filter under running water.
b. Allow the air filter to dry.
a. When the air filter is dry, place it inside the fan cover.
b. Insert the screws (Qty. 2) to secure the fan cover to the back of the
printer.
Air Filter
Screws
22