Programming Of The Door Panel - golmar Nexa Modular GB2 User Manual

G 2 AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL B
PROGRAMMING THE DOOR PANEL
Programming mode entry and exit:
To enter programming mode, press the bell button (N3301/GB2), followed by the administrator code '1234', and finally
confirm by pressing the bell button (N3301/GB2) again.
To exit programming mode, press the C button (cancel) once if it is in a programming field or twice if not.
If no button is pressed within 10 seconds, it exits programming mode.
Programming mode entry and exit is confirmed by the emitting of a long and short tone.
Programming mode structure and sequence:
Programming of the keypad functions is performed by entering the field or function code, followed by the bell button
(N3301/GB2) and the field value.
Once in programming mode, the programming sequence is as follows:
Enter the code of the field to be programmed: this code is always 2 digits. To confirm, press the bell
0 3
button (N3301/GB2) and the keypad will emit a long and then short tone indicating that the field to be
programmed is correct or three short tones if the indicated programming field does not exist.
Enter the value of the field being programmed. Once the value has been entered, press the bell button
0 5
(N3301/GB2) and the door panel will emit a long confirmation tone if the information entered is correct
or three short tones if it is not correct.
Note: If no key is pressed within 10 seconds, it will be necessary to enter the programming code and
select the programming field again.
Enter the code of the following field or press the C button (cancel) to exit programming mode.
0 1 C
or
If wrong information is entered or an access or administrator code is repeated, the door panel will emit three short tones
to indicate that the information is incorrect. If the field code to be programmed was being entered, the programming
code must be re-entered; if the field value was being entered, the field value being configured must be re-entered.
Programming
mode entry
sequence
2
'bell (N3301/GB2)' + 'administrator code' + 'bell (N3301/GB2)'.
Field
03
C
1 2 3 4
2
C
Field value
05
C C
18
1