Mitsubishi Electric F700 Instruction Manual page 161

Selection of operation mode and
operation location
(5) Selection of control source in network operation mode (Pr. 338, Pr. 339)
⋅ As control sources, there are the operation command sources that control the signals related to the inverter
start command and function selection and the speed command source that controls the signals related to
frequency setting.
⋅ In network operation mode, the commands from the external terminals and communication (inverter RS-485
terminals or communication option) are as listed below.
Pr. 338 Communication operation
Operation
command source
Location
Pr. 339 Communication speed command
Selection
Running frequency from
Fixed function
communication
(Terminal-
Terminal 2
equivalent
Terminal 4
function)
Terminal 1
Low speed operation command/
0 RL
remote setting clear
Middle-speed operation command/
1 RM
remote setting deceleration
High speed operation command/
2 RH
remote setting acceleration
3 RT Second function selection
4 AU Terminal 4 input selection
5 JOG Jog operation selection
Selection of automatic restart
6 CS
after instantaneous power failure
7 OH External thermal relay input
8 REX Fifteen speed selection
10 X10 Inverter operation enable signal
FR-HC or MT-HC connection,
11 X11 instantaneous power failure
detection
12 X12 PU operation external interlock
External DC injection brake
13 X13
operation is started
14 X14 PID control valid terminal
PU-external operation
16 X16
switchover
Output stop
24 MRS
PU operation interlock
25 STOP Start self-holding selection
37 X37 Traverse function selection
60 STF Forward rotation command
61 STR Reverse rotation command
62 RES Reset
63 PTC PID forward action switching
64 X64 PID forward action switching
65 X65 PU-NET operation switching
66 X66 NET-external operation switching
67 X67 Command source switchover
[Explanation of table]
External : Operation is valid only from external terminal signal.
NET : Control only from communication is valid
Combined : Operation is valid from either of external terminal and communication.

: Operation is invalid from either of external terminal and communication.
Compensation :Control only from external terminal signals is valid when Pr. 28 Multi-speed input compensation selection = "1"
REMARKS
⋅ The control source of communication is as set in Pr. 550 and Pr. 551.
154
0: NET
source
NET


NET
NET
NET

NET
NET
NET
0: NET 1: External
1: 2:
0: NET
External External

NET NET
 
External

External
Compensation
External NET
External NET
External NET
NET

Combined

External
External
External NET
External
External
External
NET
External NET
External
Combined
External

NET
NET
NET
External
External
External NET
External
External
External
Remarks
1: 2:
External External

NET

External
External
External
Pr. 59 = "0" (multi-
speeds)
External
Pr. 59 = "1 , 2"
(remote)
External
External
Combined
External
Pr. 59 = "0"
External
(multi-speeds)
External
External
≠
External
Pr. 79
Pr. 79 = "7"
When X12 signal
is not assigned
External
External
External
External
External
"7"