Table of Contents
Advertisement
5.9
Configure Miscellaneous (Misc Menu)
This menu allows the user to setup other miscellaneous options of the dialler.
Program Mode -> Configure Dialler -> Configure Misc.
Select to change the date and time.
The default time is displayed on the second line until a number key is pressed and a
change is initiated. The digits all need to be entered, but the delimiters (the "/" and ":")
do not.
The day is edited by entering a number as shown below:
0:Sun 1:Mon 2:Tue 3:Wed 4:Thu 5:Fri 6:Sat 7:Sun
Press <Ok> to save, or <Esc> to discard any changes.
This option allows selection of the RS232 speed of the EDAC700 RTU serial port. This
must be one of:
19200, 9600, 4800, 2400, 1200 or 300 baud
Press <Ok> to save, or <Esc> to discard changes.
Note! This setting controls the method for reloading the RTU firmware. This option is
only available to EDAC Accredited Service Centres. Please contact your local EDAC
representative for further information.
Date: 31/10/12
Page 45File: 700b Technical Manual ver1.9.3.docm
Hide quick links:
Advertisement
Table of Contents
