EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual page 35

PIN cancel
A valid PIN number for the triggered Group must be entered. The PIN required is
configured in the Group Menu. This option would normally be used when other people
might answer the phone that the EDAC700 RTU calls.
This setting is used to set the time the EDAC700 RTU is allowed on an alarm notification
call for this group. It is the time from the instant the I/O trigger causes dial-out to the
time it will hang up if no DTMF tone is received. If it takes a while for the exchange to
connect or there is a long delay before the phone is answered, then this time needs to
be increased. The time is entered in seconds.
Choose a dial out speech method. When the EDAC700 RTU makes an alarm
notification call you can set one of four options to determine the method of presenting
voice messages.
No extras
Will start speaking alarm status message straight away, the user can then press a key or
enter a PIN to acknowledge and cancel the alarm.
Report pin
Will ask for a PIN before it starts speaking the alarm status message. Any valid Group
PIN will work.
Speak Menu
Will start by speaking the Main Menu "Press 1 for....2 for...3 for...etc. Will not require a
PIN after pressing 1 to get the alarm status message.
Report PIN + Menu
Will start speaking the main menu but will ask for a PIN after pressing 1 to get the alarm
status message. Any valid Group PIN will work.
This sets the type of response to an alarm call used on this number.
Voice
A voice message will be spoken to a human recipient on a phone.
Date: 31/10/12 Page 35File: 700b Technical Manual ver1.9.3.docm