EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual page 27

This setting is the delay in seconds for the period the trigger must be continuously
present before being accepted as a valid alarm trigger.
Type in the delay in seconds for the period from the time a valid alarm trigger is present
to the time alarm notification calls are initiated.
Note! This menu choice will only appear if "Latched input" is selected from the "Input
alarm" menu choice.
Type in the delay in seconds for the period an analogue signal must remain in the
normal operating range before it is accepted as being back in normal operating range.
Choose when you want the value to be reported: on Dial in, Dial out or Both.
trig causes dial out (default)
The EDAC700 RTU will make alarm notification calls when this Input is triggered.
Report - non dial
Will report a status voice message whenever an alarm notification call is made.
Report – call in
A status voice message will be reported when a user calls the EDAC700 RTU.
Always Report
The EDAC700 RTU will make alarm notification calls when an Input is triggered. A
status voice message will be reported when the EDAC700 RTU makes an alarm
notification call or when a user calls the EDAC700 RTU.
Date: 31/10/12 Page 27File: 700b Technical Manual ver1.9.3.docm