EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual page 28

Enter a suitable pager message. If an analogue sensor has been configured, a relevant
analogue reading is added to the end of the pager message at the time of transmission.
Your pager message will need to allow for this. Eg. "Water Level is high, the reading is ".
Each I/O Sensor Configuration record can have a pager message associated with it.
Voice messages can be recorded for any input. A separate message can be recorded
for the On (alarmed) state and the Off state off the input.
If a voice message has been recorded for this input, you have the option in this setting to
play back the existing message by pressing <*>. Press <#> to start recording your On
message. Several messages are displayed while the RTU prepares to record. Wait for
the EDAC700 RTU to beep before you start your recording.
Press any key when you are finished recording. The EDAC700 RTU will play your
recording back to you. Press <Ok> to stop listening to the recording playback, then
<Ok> to move to the next setting.
This setting allows you to record an Off message. This procedure is the same as for the
On message.
Press <OK> to save and exit, or press <Esc> to discard any changes.
Date: 31/10/12 Page 28File: 700b Technical Manual ver1.9.3.docm