Installation Information; Power Up - EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual

1

Installation Information

1.1

Power Up

When power is connected to the EDAC700 RTU it will beep continuously for a short
time. During this time it will display "RUN_" on the LCD. The beeper will then stop and
the display will show a code version number like 1.4.3p under the word RUN_, for a
short time.
Note! This version number is required if you need to make any technical support calls.
After this the EDAC700 RTU goes into Run Mode and displays the Run Mode Display.
If it does anything different to this sequence and does not end up at the Run Mode
display, power it down completely, and start again, or press the Reset button located in
the top right corner.
If the battery is not connected, the EDAC700 RTU may generate a low battery alarm,
and will ask for a PIN. If this happens, connect the battery and check the supply voltage.
Press the Reset button to start again.
Date: 31/10/12
2 x 1A 20mm
Plug in terminal block,
connected to the
supplied plug pack
Page 3File: 700b Technical Manual ver1.9.3.docm
Note: The RS232
port here faces out
the right hand side of
the box. When
securing to a wall
allow about 50mm
(2") extra room for
the serial plug &
lead.
Reset Button