Detailed Edac700 Rtu Configuration - EDAC Electronics Ltd. EDAC700 RTU Technical Reference Manual

5

Detailed EDAC700 RTU Configuration

This section provides a detailed guide to every menu available on the EDAC700 RTU. It
is assumed that you are familiar with the information in the Getting Started Manual.
The entry point to each menu is described in a single line like this:
Program Mode -> Configure Dialler -> Configure I/O
This summarises the sequence of going to Program Mode by entering the correct PIN
number, then navigating to and selecting the Configure Dialler and Configure I/O menu
options.
Screen shots are included to enable you to confirm your position in the menus.
Telepermit Requirements; New Zealand
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom
NZ has accepted that the item complies with the minimum conditions for connection to
its network. It indicates no endorsement of the product by Telecom, nor does it provide
any sort of warranty. Above all, it provides no assurance that any item will work correctly
in all respects with another item of Telepermitted equipment of a different make or
model, nor does it imply that any product is compatible with all of Telecom's network
services.
This equipment shall not be set up to make automatic calls to the Telecom 111
Emergency Service.
The "max call count" parameter shall be set to a value of not more than 10.
The "wait after call (m)" parameter shall not be set to the default value of 0
Telepermitted equipment only may be connected to the auxiliary telephone port. The
auxiliary telephone port is not specifically designed for 3-wire-connected equipment. 3-
wire-connected equipment might not respond to incoming ringing when attached to this
port.
In the event of any problem with this device, it is to be disconnected, and a CPE item
connected to one of its terminal ports may be connected directly in its place. The user
should then arrange for the product to be repaired. Should the matter be reported to
Telecom as a wiring fault, and the fault is proven to be due to this product, a call-out
charge will be incurred.
Austel Requirements; Australia
The "max call count" parameter shall be set to a value of not more than 15
Date: 31/10/12 Page 23File: 700b Technical Manual ver1.9.3.docm